Repair procedures: Removal

Release the residual pressure in fuel line.
(Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
Folding the rear seat cushion.
Remove the service cover (A) of the fuel pump after loosening the screws.

Fig 1: Identifying Service Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the fuel feed tube quick - connector (A).

Fig 2: Identifying Fuel Feed Tube Quick - Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the service cover of the canister (A) in trunk room.

Fig 3: Identifying Service Cover Of Canister
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the vapor tube quick-connector (A).

Fig 4: Identifying Vapor Tube Quick-Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear - LH wheel, tire, and the inner wheel house,
Disconnect the fuel tank extension connector (A), and then remove the wiring harness from the vehicle.

Fig 5: Identifying Fuel Tank Extension Connector
Courtesy of HYUNDAI MOTOR AMERICA
Lift the vehicle.
Remove the center muffler.
(Refer to MUFFLER .
Remove the under cover (A).

Fig 6: Identifying Center Cover Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the propeller shaft.
(Refer to PROPELLER SHAFT ASSEMBLY .
Disconnect the fuel filler hose (A) and leveling hose (B).

Fig 7: Identifying Fuel Filler And Leveling Hose
Courtesy of HYUNDAI MOTOR AMERICA
Support the fuel tank with jack (A).

Fig 8: Supporting Fuel Tank Using Jack
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fuel tank (B) from the vehicle after removing the mounting nuts (A).

Fig 9: Identifying Fuel Tank And Mounting Nuts
Courtesy of HYUNDAI MOTOR AMERICA