LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Equus Signature >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Air Suspension System >> Compressor >> Repair procedures >> Removal

Repair procedures: Removal

NOTE:
  • This system combines a sensor and electronic parts with mechanical components, so be careful not to subject the system to strong impacts.
  • If any pins are visible inside the electric signaling connector, do not expose it to water.
  • A plug protects the air inlet of the reservoir tank from dust or other particles. Do not remove the plug except when assembling or disassembling the reservoir tank.
  • DO NOT hold any parts by their electric wires while moving them, as the weight of the part may damage the wire or connection during transport.
  • Do not pile components on top of each other.
  • Do not apply power to operate the compressor directly (may cause malfunctions/overheating).
  • Be careful not to break any circuits by twisting or bending the cables.
  • DO NOT drop any parts.
  • Check the color of each air hose before connecting it. After connecting a hose, pull it to ensure that the connection holds firm.
  • The air connection section of the air hose includes a dust cover to prevent the introduction of foreign substances. DO NOT remove this cap for any process besides connecting the hose.
  • When installing an air hose, be careful not to kink the hose.
  • DO NOT reuse the air hose connector connected to an air hose assembly after it has been disassembled.
  • The markings on both ends of the air hose distinguishes the assembly, so be careful not to peel it off.
  1. Removal the front bumper.

    (Refer to FRONT BUMPER COVER .

  2. Removal the left head lamp.

    (Refer to REMOVAL .

  3. Removal the EHPS motor.

    (Refer to POWER STEERING MOTOR .

  4. Disconnect the connector (A) & air hose (B).
    Fig 1: Identifying Connector And Air Hose
    G09789904Courtesy of HYUNDAI MOTOR AMERICA
    • Work with time until air is discharged.
    • Separate with push the air tube connected to center portion.
  5. Remove the bracket bolt.
    Fig 2: Identifying Bracket Bolt
    G09789905Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Identifying Bracket Bolt
    G09789906Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the solenoid valve (A) from the compressor by loosening the bolt.
    Fig 4: Identifying Solenoid Valve
    G09789907Courtesy of HYUNDAI MOTOR AMERICA
  7. Installation is the reverse of removal.
    NOTE:
    • Take care not to drop.
    • Confirm the tube color in installation process.
    • Confirm that whether the tube is escaped a not by puling it.
    • Be careful not to disconnection of cable by its twist or excessive bending.
    • Do not remove cap except assemble.
    • Take care not to twisted.
    • If disassemble the air tube connector, do not reuse it.
    • Air tube marking takes care not to be came off.
scientia non olet · About LEMON Manuals