Repair procedures: Removal

CAUTION:

Put on gloves to protect your hands.

NOTE:

Use seat covers to avoid damaging any surfaces.

Remove the roof side molding.
(Refer to "ROOF SIDE MOLDING ")
Remove the rear package tray trim.
(Refer to "REAR PACKAGE TRAY TRIM ")
Using a screwdriver or remover, remove the rear glass lower cover (A).

Fig 1: Removing Rear Glass Lower Cover
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting nuts, then remove the rear window glass side cover (A).

Fig 2: Identifying Rear Window Glass Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
Spread the WD-40 on the side of rear window glass.
Cut out the adhesive using the cutter (A).
Information
- Please use the cutter with a blade length between 8-12 inches.
  
  Fig 3: Cutting Out Adhesive Using Cutter
  Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on the edge (B) while pulling the piano wire (A) left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 4: Identifying Sealant Cutting Position
Courtesy of HYUNDAI MOTOR AMERICA
If a piano wire is visible inside the chassis, pull the piano wire (A) line inside.

Fig 5: Cutting Sealant Using Piano Wire
Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on (A-A), (B-B), (C-C), while pulling a piano wire (A) left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 6: Cutting Sealant Using Piano Wire
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear window glass (A).
NOTE:
- When removing and installing the rear window glass, an assistant is necessary.
Fig 7: Identifying Rear Window Glass
Courtesy of HYUNDAI MOTOR AMERICA