Component Inspection

WARNING: This page is about a different variant/trim than selected.

Push the ignition lock switch in the direction of the arrow to make sure that continuity between terminals. (refer to the table below)

Standard value:

Full stroke (A): 12.0 ± 0.3mm (0.4724 ± 0.0118 in.)

ON-OFF point (B): 2.0 mm (0.0787 in.)

Fig 1: Checking Continuity Between Lock Switch Signal Connector Terminal 1 And Chassis Ground

Courtesy of HYUNDAI MOTOR AMERICA

NOTICE

Condition	Clutch Pedal pressed	Clutch Pedal Released
Switch Operation	ON (below 1.0Ω)	OFF (Infinite Ω)