Repair procedures: Removal

Shift Lever Assembly Replacement

Remove the floor Interior console assembly.
(Refer to "CONSOLE ")
Remove the cover (A).

Fig 1: Removing Shift Lever Assembly Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the select cable (B) by removing the snap pin (A).

Fig 2: Removing Select Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Fig 3: Removing Shift Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable (B) by removing the clip (A).

Fig 4: Removing Shift Cable Clip
Courtesy of HYUNDAI MOTOR AMERICA

Fig 5: Shift Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.

Shift Cable Replacement

Remove the floor Interior console assembly.
(Refer to "CONSOLE ")
Remove the cover (A).

Fig 6: Removing Shift Lever Assembly Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the select cable (B) by removing the snap pin (A).

Fig 7: Removing Select Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Fig 8: Shift Lever Assembly Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable (B) by removing the clip (A).

Fig 9: Removing Shift Cable Clip
Courtesy of HYUNDAI MOTOR AMERICA

Fig 10: Shift Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the retainer (A) and nuts (B-2ea).
Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

Fig 11: Shift Lever Assembly Retainer And Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the select and shift cable assembly (B) after removing the pin (A).

Fig 12: Removing Shift Cable Assembly Pin
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable and select cable at cabin room.