LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Accent GLS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Airbag Modules & Clock Spring) >> Passenger Airbag (PAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2012 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
  3. Place a Passenger Airbag (PAB) on the crash pad and tighten the Passenger Airbag (PAB) mounting nuts.

    Tightening torque 

    : 0.9 ~ 1.4 kgf.m (8.8 ~ 13.7 N.m, 6.5 ~ 10.1 lb.ft)

  4. Install the heater duct to the crash pad.
  5. Install the crash pad. (Refer to CRASH PAD .)
  6. Tighten the PAB mounting bolt.

    Tightening torque 

    : 1.9 ~ 2.7 kgf.m (18.6 ~ 26.5 N.m, 13.7 ~ 19.5 lb.ft)

  7. Connect the Passenger Airbag (PAB) harness connector to the SRS main harness connector.
  8. Reinstall the glove box. (Refer to CRASH PAD .)
  9. Reconnect the battery negative cable.
  10. After installing the Passenger Airbag (PAB), confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals