LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Accent GLS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Airbag Modules & Clock Spring) >> Knee Airbag (KAB) Module >> Repair procedures >> Installation

Repair procedures: Installation

WARNING: This page is about a different car, the 2014 Hyundai Santa Fe Sport and 2013 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Connect the knee airbag connector.
  4. Tighten the knee airbag mounting nuts.

    Tightening torque: 

    7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

  5. Install the crash pad lower panel.

    Refer to CRASH PAD LOWER PANEL .

  6. Install the crash pad side cover.

    Refer to CRASH PAD SIDE COVER .

  7. Reconnect the battery negative cable.
  8. After installing the knee airbag, confirm proper system operation:
    1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals