LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Veloster Turbo, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System - Non-Turbo) >> ETC (Electronic Throttle Control) System >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the resonator and the air intake hose (Refer to "Intake And Exhaust System ").
  3. Disconnect the ETC module connector (A).
    Fig 1: Identifying ETC Module Connector
    G08807012Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolts, and then remove the ETC module (A) from the engine.
    Fig 2: Identifying ETC Module
    G08807013Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals