LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Veloster Turbo, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Fuel Delivery System - Non-Turbo) >> Fuel Pump >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE " .
  2. Remove the rear seat [LH] (Refer to "Seat ").
  3. Remove the fuel pump service cover (A).
    Fig 1: Fuel Pump Service Cover
    G08807105Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel pump connector (A).
  5. Disconnect the fuel feed tube quick connector (B).
  6. Disconnect the fuel tank pressure sensor connector (C).
  7. Disconnect the vapor tube quick-connector (D).
  8. Remove the plate cover (E) after removing the installation bolts, and then remove the fuel pump from the fuel tank.
    Fig 2: Fuel Pump, Feed Tube, Pressure Sensor & Vapor Tube Connectors
    G08807106Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Fuel Pump Assembly
    G08807107Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals