LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> Dismounting/Mounting Procedures >> Tire Pressure Sensor >> Removal

Tire Pressure Sensor: Removal

  1. Remove the wheel and tire assembly.
    2. CAUTION: Avoid tire/tool contact with the valve while dismounting tire.
  2. Deflate tire and remove balance weights. The tire bead should be broken about 180 degrees from the valve side of the wheel. The bead breaker should not be set too deep. Dismount should end near the valve.
  3. While handling sensor with care, remove valve nut.
    CAUTION: The valve nut should not be re-used.
  4. Discard the valve stem assembly.
scientia non olet · About LEMON Manuals