LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Troubleshooting >> Starter Solenoid Test

Starter Solenoid Test

  1. Disconnect the field coil wire from the M-terminal of solenoid switch.
  2. Connect the battery as shown in illustration. If the starter pinion pops out, it is working properly. To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
    Fig 1: Performing Starter Solenoid Test
    G08833986Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the battery from the M terminal.

    If the pinion does not retract, the hold-in coil is working properly. To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.

    Fig 2: Disconnecting Battery From M Terminal Of Solenoid Switch
    G08833987Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the battery also from the body. If the pinion retracts immediately, it is working properly. To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
    Fig 3: Disconnecting Battery Connection From Starter Body
    G08833988Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals