LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Thermostat >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Place the thermostat in the block.

    Install the thermostat (B) with the jiggle valve upward.

  2. Install the water inlet fitting (A).

    Tightening torque: 

    18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

    Fig 1: Water Inlet Fitting And Thermostat
    G09150175Courtesy of HYUNDAI MOTOR AMERICA
  3. Fill with engine coolant.
  4. Start engine and check for leaks.
scientia non olet · About LEMON Manuals