LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Sonata GLS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Air Conditioning System (HEV)) >> Receiver-Drier >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.

    Tightening torque: 

    20~25N.m (2.0~2.5kgf.m, 14.5~18.2lb-ft)

    Fig 1: Removing Bottom Cap With L Wrench From Condenser
    G07319451Courtesy of HYUNDAI MOTOR CO.
  2. Remove the desiccant (A) from the condenser using a long nose plier. Check for crumbled desiccant and clogged bottom cap filter.
    Fig 2: Locating Desiccant
    G07319452Courtesy of HYUNDAI MOTOR CO.
  3. Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap.
  4. Insert the new desiccant into the receiver drier tank. The desiccant must be sealed in vacuum before it is exposed to air for use.
  5. Install the new bottom cap to the condenser.
    NOTE:
    • Always replace the desiccant and bottom cap at the same time.
    • Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
    • Be careful not to damage the radiator and condenser fins when installing the condenser.
    • Be sure to install the lower mount cushions of the condenser securely into the holes.
    • Charge the system, and test its performance.
scientia non olet · About LEMON Manuals