LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Genesis Coupe 2.0T R-Spec >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Engine Control System - 2.0L) >> Engine Control Module (ECM) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2012 Hyundai Genesis Coupe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the case of the vehicle equipped with immobilizer, perform "Key Teaching" procedure together (Refer to TEACHING PROCEDURES .
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the front strut assembly (Refer to FRONT SUSPENSION SYSTEM ).
  3. Disconnect the ECM Connector (A).
    4. Fig 1: Identifying ECM Connector, TCM Connector, ECM Bracket Bolts, & Nut
    G06514126Courtesy of HYUNDAI MOTOR CO.
  4. Disconnect the TCM connector (B) [A/T].
  5. Remove the ECM bracket installation bolts (C) and nut (D).
scientia non olet · About LEMON Manuals