Repair Procedures: Disassembly

Remove center bolt (B) while is catching pulley outside order page by special tool (A).
TORQUE: 10~15N.m (1.02~1.53kgf.m, 7.37~11lbf.ft)

Fig 1: Removing Center Bolt Using Tool
Courtesy of HYUNDAI MOTOR AMERICA
Remove disk from pulley to clockwise after set special tool (B) in hall of disk upper part after remove center bolt (A).

Fig 2: Removing Disk From Pulley Using Special Tool (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Removing Disk From Pulley Using Special Tool (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
If you removal the field coil, remove retainer ring (A) with retainer ring pliers.
NOTE:
- Be careful not to damage the pulley (B) and compressor during removal/installation.
- Once retainer ring (A) is removed, replace it with a new one.
Fig 4: Identifying Pulley And Retainer Ring
Courtesy of HYUNDAI MOTOR AMERICA
Reassemble the compressor clutch in the reverse order of disassembly, and note these items:
1. Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
2. Install new retainer rings, and make sure they are fully seated in the groove.
3. Make sure that the pulley turns smoothly after its reassembled.