LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Genesis 3.8 >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control (ESC) Diagnosis >> DTC C1203: Wheel Speed Sensor Front-RH Open/Short >> Scantool Diagnostics >> Monitor Scantool Data

Monitor Scantool Data

  1. Start engine.
  2. Connect scantool to Data Link Connector (DLC).
  3. Drive vehicle in gear and maintain vehicle speed at or above 10km/h. (6.2mph)
  4. Monitor the "WHEEL SPEED (Front-Right)" parameter on the Scantool

    Specification:  Compare with other service data related to wheel speed sensor.

    If it is the same as other service data, it is in normal condition.

  5. Is the service data displayed within specifications?

    YES 

    • Fault is intermittent caused by poor connection in wheel speed sensor harness and/or HECU's connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals