Repair Procedures: Installation

Tightening torque 

Bolt:

19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft)

Nuts:

11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)

Fig 1: Oil Screen And Gasket

Courtesy of HYUNDAI MOTOR AMERICA

1. Using a gasket scraper, remove all the old packing material from the gasket surfaces.
2. The sealant locations on the oil pan and the lower crankcase must be free of harmful foreign materials, oil, dust and moisture.

   Spraying cleaner on the surface and wiping with a clean duster.

3. After applying liquid sealant on the oil pan, assemble it within 5 minutes after sealant was applied. Continuous bead of sealant should be applied to prevent any path of oil leakage.

   Bead width 

   Whole section: 4.0 ~ 5.0 mm (0.16 ~ 0.20 in.)

   Section A: 1.5 ~ 2.5 mm (0.06 ~ 0.10 in.)

   Sealant:  Threebond 1217H

   Fig 2: Sealant Application Area On Oil Pan

   Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION:

   • When applying sealant gasket, sealant must not be protruded into the inside of oil pan.
   • To prevent leakage of oil, apply sealant gasket on the inner threads of the bolt holes.
   • If the sealant is applied to the bottom surface of the lower crankcase, it should be the same position as the oil pan.
4. Install the oil pan (A). Uniformly tighten the bolts in several passes.

   Tightening torque: 

   9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

   Fig 3: Oil Pan And Bolts

   Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION: After assembly, wait at least 30 minutes before filling the engine with oil.
   CAUTION: Always use a new drain plug gasket.