LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2013 >> Elantra Limited >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Alternator >> Repair procedures >> Disassembly

Repair procedures: Disassembly

  1. Remove the rear cover (A) after removing nuts (B).
    Fig 1: Rear Cover And Nuts
    G10234401Courtesy of HYUNDAI MOTOR AMERICA
  2. Remove the mounting bolts (A) and the regulator assembly (B).
    Fig 2: Regulator Assembly Mounting Bolts
    G10234402Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the slip ring guide (A) after pulling it.
    Fig 3: Removing Slip Ring Guide
    G10234403Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the OAD (Overrunning Alternator Decoupler) cap.
    NOTE:
    • When installing, replace with new OAD cap.
  5. Remove the OAD (Overrunning Alternator Decoupler) pulley (A) using the special tool.
    Fig 4: Overrunning Alternator Decoupler Pulley
    G10234404Courtesy of HYUNDAI MOTOR AMERICA
  6. Unsolder the 3 stator leads (A).
    Fig 5: Stator Leads
    G10234405Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the 4 through bolts (A).
    Fig 6: Through Bolts
    G10234406Courtesy of HYUNDAI MOTOR AMERICA
  8. Disconnect the rotor (A) and housing (B).
    Fig 7: Rotor And Housing
    G10234407Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals