Function Of Safety Power Window

When all door (Front, Rear) power window auto-up switch is operated, safety function is activated.

1. Safety function condition

   When detect the force of 100 N during the window rising, window is reversed.

2. Length of window reversing (except holding the auto-up switch)
   1. When detect the jamming during the 4 mm ~ 250 mm from top of the door.

      → Window is reversed until 300 mm from top of the door.

      Fig 1: Power Window Top Of Travel Reversing

      Courtesy of HYUNDAI MOTOR AMERICA
   2. When detect the jamming over the 250 mm from top of the door.

      → Window is reversed until 50 mm from jamming position.

      → Window is reversed 50 mm or bottom position in case of 50 mm reversing distance.

      Fig 2: Power Window Bottom Of Travel Reversing

      Courtesy of HYUNDAI MOTOR AMERICA
   3. When detect the jamming over 300 mm from top of the door.

      → Window stops at reverse point.

3. Length of window reversing (holding the auto-up switch)
   1. When detect the jamming during holding the auto-up switch.

      → Window is reversed until 25 mm from jamming position.

   2. Auto-up function is not available during the 5 seconds from above condition.

      → When holding the auto-up switch, window is operated as a manual-up function. (Safety function is not activated.)

   3. When detect the jamming during holding the auto-up switch again.

      → Window is reversed until 25 mm from jamming position.

   4. When holding the auto-up switch after 5 seconds from above condition.

      → Window is reverse until 25 mm from jamming position.

      Fig 3: Power Window Jamming Position Holding The Auto-Up Switch

      Courtesy of HYUNDAI MOTOR AMERICA
4. Safety function is not available area

   Safety function is not available during the 4 mm from top of the door.