Repair Procedures: Installation

WARNING: This page is about a different car, the 2014 Hyundai Veloster and 2013 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.

Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
Install the water inlet fitting (A).
Tightening torque:

18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Fig 1: Water Inlet Fitting And Thermostat
Courtesy of HYUNDAI MOTOR AMERICA
Fill with engine coolant.
Start engine and check for leaks.