LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Veloster Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Oil Pressure Switch >> Repair procedures >> Inspection

Repair procedures: Inspection

  1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.
    Fig 1: Checking Continuity Between Terminal And Body Using Ohmmeter
    G08806789Courtesy of HYUNDAI MOTOR AMERICA
  2. Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.
    Fig 2: Checking Continuity Between Terminal And Body When Fine Wire Is Pushed
    G08806790Courtesy of HYUNDAI MOTOR AMERICA
  3. If there is no continuity when a 49.0kpa (0.5kg/cm2 , 7.1psi) is applied through the oil hole, the switch is operating properly.

    Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

scientia non olet · About LEMON Manuals