Repair Procedures: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the connector (A), and then remove the sensor (B).
NOTE: Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.

[Bank 1/Sensor 1]

Fig 1: Locating Heated Oxygen Sensor Connector (Bank 1/Sensor 1)
Courtesy of HYUNDAI MOTOR CO.

Fig 2: Locating Heated Oxygen Sensor (Bank 1/Sensor 1)
Courtesy of HYUNDAI MOTOR CO.

[Bank 1/Sensor 2]

Fig 3: Locating Heated Oxygen Sensor Connector (Bank 1/Sensor 2)
Courtesy of HYUNDAI MOTOR CO.

Fig 4: Locating Heated Oxygen Sensor (Bank 1/Sensor 2)
Courtesy of HYUNDAI MOTOR CO.

[Bank 2/Sensor 1]

Fig 5: Locating Heated Oxygen Sensor Connector (Bank 2/Sensor 1)
Courtesy of HYUNDAI MOTOR CO.

Fig 6: Locating Heated Oxygen Sensor (Bank 2/Sensor 1)
Courtesy of HYUNDAI MOTOR CO.

[Bank 2/Sensor 2]

Fig 7: Locating Heated Oxygen Sensor Connector (Bank 2/Sensor 2)
Courtesy of HYUNDAI MOTOR CO.

Fig 8: Locating Heated Oxygen Sensor (Bank 2/Sensor 2)
Courtesy of HYUNDAI MOTOR CO.