Procedure Of ATF Level Adjusting
- Park the vehicle on a flat road and lock the tires.
- Shift the shift lever to the "P" range.
- Remove the overflow plug by using a torx wrench.
- Remove the filler plug by using a torx wrench.
- Check if ATF flows out of the overflow hole. If ATF does not drop, add ATF until it drops.
- Fix the overflow plug by using Torx wrench.NOTE: Reuse the used gasket.
- Add 1400cc of ATF from the oil filling hole.
- Install it to the filler plug with a new gasket.
- Tighten the filler plug by using Torx wrench with the specified torque.
Tightening torque:
15~25 Nm (1.5~2.5 kgf.m, 11.1~18.4 lb-ft)
- Start the engine.
- Raise ATF temperature on CAN signal up to 50°C at stabilized idle speed condition.
- Shift from "P" to "D", then from "D" to "P", keeping each shift position "N", "R" more than 2 seconds with foot braking.
- Repeat 2 times above procedure "3".
- Remove the overflow plug and the O-ring by using Torx wrench.
- Check If the thin oil stream becomes drop by drop when ATF temperature on CAN signal is at 58~64°C.
- Install it to the overflow plug with a new gasket.
- Tighten the overflow plug by using Torx wrench with the specified torque.
Tightening torque:
35~45 Nm (3.6~4.6 kgf.m, 25.8~33.2 lb-ft)
NOTE: Be sure to wipe off spilled ATF completely after tightening the overflow plug.