LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Genesis 3.8 >> Repair and Diagnosis >> Body & Frame >> Mirrors >> Exterior Body Panels >> Rear Door >> Repair procedures >> Replacement >> Module Assembly Replacement

Module Assembly Replacement

  1. Remove the following parts:
    1. Door trim
    2. Window glass
    3. Outside handle
  2. Loosen the mounting screw (A).
    Fig 1: Identifying Module Assembly And Mounting Screw
    G08852982Courtesy of HYUNDAI MOTOR AMERICA
  3. After loosening the door module mounting bolts, remove the door module (A).
    Fig 2: Identifying Door Module Mounting Bolts
    G08852983Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the connector (B).
  5. Detach the clips, then remove the wiring harness (C).
    Fig 3: Identifying Wiring Harness And Connector
    G08852984Courtesy of HYUNDAI MOTOR AMERICA
  6. Installation is the reverse of removal.
    NOTE:
    • The area of whole parts should be applied with sufficient grease.
    • Make sure connectors are connected properly and each rod is connected securely.
    • Make sure door lock operates and open/closes properly.
scientia non olet · About LEMON Manuals