Repair Procedures: Installation
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
- Place a Passenger Airbag (PAB) on the crash pad and tighten the Passenger Airbag (PAB) mounting nuts.
Tightening torque:
4.9 ~ 7.8 N.m (0.5 ~ 0.8 kgf.m, 3.6 ~ 5.8 lb-ft)
- Install the heater duct to the crash pad.
- Install the crash pad. (Refer to CRASH PAD )
- Tighten the PAB mounting bolt.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
- Connect the Passenger Airbag (PAB) harness connector to the SRS main harness connector.
- Reinstall the glove box. (Refer to CRASH PAD )
- Reconnect the battery negative cable assembly.
- After installing the Passenger Airbag (PAB), confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.