LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Equus Signature >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Oil Pump >> Repair procedures >> Removal

Repair procedures: Removal

  1. Remove the sub frame. (Refer to FRONT AIR SUSPENSION SYSTEM )
  2. Drain engine oil.
    1. Remove the oil filler cap.
    2. After lifting the car, remove the oil drain plug and drain oil into a container.
      Fig 1: Identifying Engine Oil Drain Plug
      G08829946Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the oil filter & cooler assembly (A).
    Fig 2: Identifying Oil Filter & Cooler Assembly
    G08829947Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the lower oil pan (A).

    Insert the blade of SST (09215-3C000) between the upper oil pan and the lower oil pan. Cut off applied sealer and remove the lower oil pan.

    Fig 3: Removing Lower Oil Pan Using SST (09215-3C000)
    G08829948Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Insert the SST between the lower oil pan and the upper oil pan by tapping it with a plastic hammer in the direction of (1) arrow.
    • After tapping the SST with a plastic hammer along the direction of (2) arrow around more than 2/3 edge of the lower oil pan, remove it from the lower oil pan.
    • Do not use the SST as a prybar. Hold the tool in position (on the gasket line) and tap in with a light hammer.
    • Be careful not to damage the contact surfaces of upper oil pan and lower oil pan.
  5. Remove the upper oil pan (A).

    Insert the blade of SST (09215-3C000) between the upper oil pan and the cylinder block. Cut off applied sealer and remove upper oil pan.

    Fig 4: Removing Upper Oil Pan Using SST (09215-3C000)
    G08829949Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Insert the SST between the upper oil pan and the cylinder block by tapping it with a plastic hammer in the direction of (1) arrow.
    • After tapping the SST with a plastic hammer along the direction of (2) arrow around more than 2/3 edge of the upper oil pan, remove it from the upper oil pan.
    • Do not use the SST as a prybar. Hold the tool in position (on the gasket line) and tap in with a light hammer.
    • Be careful not to damage the contact surfaces of Upper oil pan and cylinder block.
  6. Separate the sprocket (A) and the chain (B) from the oil pump after remove the sprocket bolt.
    Fig 5: Identifying Chain And Sprocket
    G08829950Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the oil pump assembly (A).
    Fig 6: Identifying Oil Pump Assembly
    G08829951Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals