Monitor Scantool data

1. Connect scantool to Data Link Connector (DLC).
2. IGN "ON" & Engine "OFF"
3. Monitor the "KEY STATUS", "SMARTRA STATUS" and "ECU STATUS" Parameter on the Scantool.

   Specification  : 'LEARNT'

   Fig 1: Current Data Chart

   Courtesy of HYUNDAI MOTOR CO.
4. Is "ECU STATUS" Parameter "Locked"?

YES 

• Keep "KEY ON" status for 1 hours to withdraw "Locked by Timer" status. Then register transponder and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO 

• Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.