LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Elantra Touring SE, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Brake System) >> Master Cylinder >> Disassembly

Master Cylinder: Disassembly

WARNING: This page is about a different car, the 2011 Hyundai Elantra Touring. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the reservoir cap and drain the brake fluid into a suitable container.
  2. Remove the reservoir (C) from the master cylinder (B) after remove the mounting screw (A).
    Fig 1: Identifying Reservoir, Master Cylinder And Mounting Screw
    G06144801Courtesy of HYUNDAI MOTOR CO.
  3. Remove the retainer ring (A) by using the snap ring pliers.
  4. Remove the primary piston assembly (B).
  5. Remove the pin (D) with the secondary piston (C) pushed completely using a screwdriver. Remove the secondary piston assembly (C).
    Fig 2: Identifying Primary Piston Assembly, Pin, Secondary Piston And Retainer Ring
    G05331050Courtesy of HYUNDAI MOTOR CO.
    NOTE: Do not disassemble the primary and secondary piston assembly.
scientia non olet · About LEMON Manuals