Repair Procedures: Removal

Disconnect the negative (-) battery terminal.
Remove the steering column upper and lower shrouds.
(Refer to "STEERING COLUMN AND SHAFT ").
Remove the ignition switch (A) after loosening the screw (B) with IG ON and disconnecting the 6P connector (C).

Fig 1: Identifying Ignition Switch With Screw
Courtesy of HYUNDAI MOTOR CO.

Fig 2: Identifying 6P Connector
Courtesy of HYUNDAI MOTOR CO.
Remove the door warning switch and key illumination lamp (A) after loosening the screw and disconnecting the 6P connector (B).

Fig 3: Identifying Key Illumination Lamp And 6P Connector
Courtesy of HYUNDAI MOTOR CO.
If it is necessary to remove the key lock cylinder (A), Remove the key lock cylinder after pushing lock pin (B) with key ACC.

Fig 4: Identifying Key Lock Cylinder And Lock Pin
Courtesy of HYUNDAI MOTOR CO.