Repair Procedures: Reassembly
- Wrap tape around the driveshaft spline (TJ) to prevent damage to the boots.
- Apply grease to the joint boot on the side of the wheel and install the boot.
- Install the clamp.
Courtesy of HYUNDAI MOTOR CO.
- Assemble the transaxle side joint boot and bands.
- Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).
Courtesy of HYUNDAI MOTOR CO.
Courtesy of HYUNDAI MOTOR CO.
- Add specified grease to the joint boot as much as it was wiped away at inspection.
- Install the both boot band.