LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Elantra GLS, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Immobilizer System >> Repair Procedures >> Replacement >> Neutralizing Of SMARTRA

Neutralizing Of SMARTRA

The EMS can be set to the status of "neutral" by the tester.

Ignition key (regardless of key status) is inserted and after IGN ON. If receiving the correct vehicle password from GST, SMARTRA can be neutralized. The neutralization of SMARTRA is possible if DPN is same as the value inputted by GST.

In case that the SMARTRA status is neutral, the EMS keeps the lock state. And the start is not possible by "twice ignition".

In case of changing the vehicle password, new virgin transponder must be only used. And in case of virgin key, after Learning the key of vehicle password, it can be used.

If wrong vehicle specific data have been sent to SMATRA three times continuously or intermittently, the SMATRA will reject the request to enter neutral mode for one hour. Disconnecting the battery or other manipulation cannot reduce this time. After connecting the battery the timer starts again for one hour.

NOTE:
  • Neutralizing Setting condition:
    • In case of "SMARTRA status", "Learnt"
    • Input correct Pin code by tester
  • Neutralizing meaning:
    • Vehicle password (DPN Code) & SEK Code deletion.
    • Permission of New DPN Learning.
Fig 1: Function Reference Chart
G07256930Courtesy of HYUNDAI MOTOR CO.
Fig 2: Scantool Display - ID Register
G07256931Courtesy of HYUNDAI MOTOR CO.
Fig 3: Scantool Display - SMATRA Neutral Mode
G07256932Courtesy of HYUNDAI MOTOR CO.
Fig 4: Scantool Display - SMATRA Neutral Mode
G07256933Courtesy of HYUNDAI MOTOR CO.
Fig 5: Scantool Display - SMATRA Neutral Mode
G07256934Courtesy of HYUNDAI MOTOR CO.
Fig 6: Scantool Display - SMATRA Neutral Mode
G07256935Courtesy of HYUNDAI MOTOR CO.
Fig 7: Scantool Display - Current Data
G07256936Courtesy of HYUNDAI MOTOR CO.