LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Accent SE, Standard Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System/Electronic Stability Control Diagnosis >> DTC C1260: Steering Angle Sensor Circuit-Signal >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. IG "ON", ENG "ON".
  3. Turn the steering wheel to the left or right.
  4. Monitor the "STEERING SNSR" parameters on the GDS.

    Specification:  If the parameters are changed according to wheel position during steering the wheel, it is normal condition.

    Fig 1: Display - Steering Angle Sensor Test Condition (Ignition "On" & Engine "On")
    G08805015Courtesy of HYUNDAI MOTOR AMERICA

    Normal Data

  5. Whenever steering wheel is turned, is the steering sensor's scantool data changed?

    YES 

    • Fault is intermittent caused by poor connection in steering sensor harness and/or HECU's connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals