Component Inspection
- longitudinal G sensor Calibration
- IG ON, ENG OFF
- Stand the vehicle on a flat ground without any inclination.
- Set the steering wheel at the center position.
- Keep the vehicle under normal tire pressure condition and normal loading condition.
- Connect GDS to Data Link Connector (DLC).
- Is "Longitudinal sensor's calibration" completed normally?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good Longitudinal G sensor and check for proper operation.
If problem is corrected, replace Longitudinal G sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure