LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2011 >> Santa Fe SE, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - G3.5 DOHC >> Knock Sensor (KS) >> Repair procedures >> Removal

Repair procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the knock sensor connector (A).

    [Bank 1] 

    Fig 1: Locating Knock Sensor Connector (Bank 1)
    G06844900Courtesy of HYUNDAI MOTOR CO.

    [Bank 2] 

    Fig 2: Locating Knock Sensor Connector (Bank 2)
    G06844901Courtesy of HYUNDAI MOTOR CO.
  3. Remove the intake manifold. (Refer to INTAKE AND EXHAUST SYSTEM .)
  4. Remove the installation bolt (A), and then remove the sensor from the cylinder block.

    [Bank 1] 

    Fig 3: Locating Knock Sensor Bolt (Bank 1)
    G06844902Courtesy of HYUNDAI MOTOR CO.

    [Bank 2] 

    Fig 4: Locating Knock Sensor Bolt (Bank 2)
    G06844903Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals