Rear Side Impact Sensor
CAUTION:
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
- Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.
Tightening torque
: 6.8 ~ 8.8 Nm (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb.ft)
- Install the rear seat side back. (Refer to SEAT )
- Install the rear seat. (Refer to SEAT )
- Reconnect the battery negative cable.
- After installing the Side Impact Sensor, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.