Battery Test Procedure: Notes

1. Connect the tester to the battery.
   1. Red clamp to battery positive (+) terminal.
   2. Black clamp to battery negative (-) terminal.
   Fig 1: Connecting Tester To Battery

   Courtesy of HYUNDAI MOTOR CO.
   CAUTION: Connect clamps securely. If "CHECK CONNECTION" message is displayed on the screen, reconnect clamps securely.
2. The tester will ask if the battery is connected "IN-VEHICLE" or "OUT-OF-VEHICLE". Make your selection by pressing the arrow buttons; then press ENTER.
   Fig 2: Screen Display - Select Test

   Courtesy of HYUNDAI MOTOR CO.
3. Select CCA and press the ENTER button.
   Fig 3: Screen Display - Select Input

   Courtesy of HYUNDAI MOTOR CO.
   NOTE: CCA: Cold cranking amps, is an SAE specification for cranking battery at -0.4°F (-18°C).
4. Set the CCA value displayed on the screen to the CCA value marked on the battery label by pressing up and down buttons and press ENTER.
   Fig 4: Screen Display - Set Rating

   Courtesy of HYUNDAI MOTOR CO.
   NOTE: The battery ratings(CCA) displayed on the tester must be identical to the ratings marked on battery label.
5. The tester will conduct battery test.
   Fig 5: Screen Display - Testing

   Courtesy of HYUNDAI MOTOR CO.
6. The tester displays battery test results including voltage and battery ratings.

Refer to the following table and take the appropriate action as recommended by the Micro 570.

Fig 6: Screen Display - Good Battery

Courtesy of HYUNDAI MOTOR CO.