LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2010 >> Azera GLS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (2 Of 3) >> DTC P0196: Engine Oil Temperature Sensor-Range/Performance >> Inspection/Repair >> Component Inspection

Component Inspection

  1. Check resistance of OTS
    1. IG "ON" & ENG "OFF"
    2. Monitor Oil Temperature parameter on the scantool
    3. IG "OFF" & ENG "OFF"
    4. Disconnect OTS connector.
    5. Measure resistance between terminal 1 and 2 of OTS connector after checking out the oil temperature with scantool

      Specification 

      RESISTANCE SPECIFICATION

      Temperature (°C/°F) Resistance (kΩ)
      -20°C/-4°F 16.52kΩ
      20°C/68°F 2.45kΩ
      80°C/176°F 0.29kΩ
      Fig 1: Measuring Resistance Between Terminal 1 And 2 Of OTS Connector
      G06800133Courtesy of HYUNDAI MOTOR CO.
    6. Is the measured resistance within specification?

      YES 

      NO 

      • Substitute with a known - good OTS and check for proper operation. If the problem is corrected, replace OTS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals