Component Inspection

Check Rainsensor

Connect scantool to Data Link Connector (DLC).
Ignition "ON" & engine "OFF" & wiper "AUTO".

Measure waveform between terminal "4" of rainsensor and chassis ground while sprinkling water on front window glass.

Specification: Duty cycle > 66.7% ± 3%

Fig 1: Measuring Waveform Between Terminal 4 Of Rainsensor And Chassis Ground

Courtesy of HYUNDAI MOTOR CO.

Fig.1)

DUTY CYCLE REFERENCE CHART

Mode	Duty Cycle
OFF	9.5% ± 3%
Fault 1 Detected	23.8% ± 3%
Fault 2 Detected	38.0% ± 3%
Fault 3 Detected	52.4% ± 3%
Rain Detected	66.7% ± 3%
Low Speed Request	81.0% ± 3%
High Speed Request	95.2% ± 3%

Fig 2: Duty Cycle Of Rainsensor

Courtesy of HYUNDAI MOTOR CO.

Is the measured waveform within specifications?
* Duty cycle value will be fixed at 23.8%±3%, if fault 1 is detected.

YES
- Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good rainsensor and check for proper operation. If the problem is corrected, replace rainsensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.