Monitor Scantool Data

WARNING: This page is about a different variant/trim than selected.

Connect scantool with data link connector (DLC)
Engine "ON".
Monitor the "OUTPUT SPEED SENSOR" parameter on the scantool
Driving at speed of over 19 Mile/h (30 Km/h)
Specification: Increasing gradually

Fig 1: Input Speed Sensor - Signal Waveform & Data (Driving Condition)
Courtesy of HYUNDAI MOTOR CO.

Fig 2: Input/Output Sensor - Signal Waveform & Data (Low Speed Driving Condition)
Courtesy of HYUNDAI MOTOR CO.

Fig 3: Input/Output Sensor - Signal Waveform & Data (High Speed Driving Condition)
Courtesy of HYUNDAI MOTOR CO.
Does "output speed sensor " follow the reference data?
YES
- Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION VEHICLE REPAIR " procedure
NO
- Go to W/Harness Inspection & procedure