LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2009 >> Genesis 3.8 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> SRS Control Module (SRSCM) >> Seat Belt Buckle Switch (BS) >> Installation

Seat Belt Buckle Switch (BS): Installation

CAUTION: Be sure to install the harness wires not to be pinched or interfered with other parts.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Remove the ignition key from the vehicle.
  3. Install the seat belt buckle switch.

    Tightening Torque 

    : 39.2 ~ 53.9 Nm (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb.ft)

  4. Install the front seat assembly. (Refer to SEAT )
  5. Reconnect the battery negative cable.
  6. After installing the Seat Belt Buckle Switch, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
scientia non olet · About LEMON Manuals