Component Inspection
- Check resistance of ECTS
- IG "OFF" and disconnect ECTS connector.
- Measure resistance between terminal 1 and 3 of ECTS connector. (Component Side)
SPECIFICATION:
TEMPERATURE AND RESISTANCE CHARTTemp. (°C/°F) Resistance (kΩ) Temp. (°C/°F) Resistance (kΩ) -40 (-40) 48.14 40 (104) 1.15 -20 (-4) 14.13 ~ 16.83 60 (140) 0.59 0 (32) 5.79 80 (176) 0.32 20 (68) 2.31 ~ 2.59 - Is the measured resistance within specification?
YES
- Clear DTC and Test-drive under enable conditions above-mentioned.
After the test, If this DTC is set, recheck it thoroughly. If not, it is intermittent fault, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good ECTS and check for proper operation.
If the problem is corrected, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Clear DTC and Test-drive under enable conditions above-mentioned.