LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2009 >> Entourage GLS >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Tail Gate System >> Power Tail Gate System >> PTG Power Latch >> Replacement

PTG Power Latch: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the tail gate trim (Refer to TAIL GATE ).
  3. Remove the tail gate handle rod, actuator rod and key rod.
  4. Remove the unlatch actuator assembly (A) after removing the connector and nuts (3EA).
    Fig 1: Identifying Unlatch Actuator Assembly
    G05325313Courtesy of HYUNDAI MOTOR CO.
  5. Remove the tail gate handle rod (A) and connector (B) from the cinching latch assembly (C).
    Fig 2: Identifying Tail Gate Handle Rod And Connector
    G05325314Courtesy of HYUNDAI MOTOR CO.
  6. Remove the latch mounting screws (3EA) and cinching latch assembly (A) from the tail gate.
    Fig 3: Identifying Latch Mounting Screws (3EA) And Cinching Latch Assembly
    G05325315Courtesy of HYUNDAI MOTOR CO.
  7. Installation is the reverse of removal.
NOTE:
  • Check the power tail gate for normal operation.
  • Check the normal operating whenever a power tailgate component is removed or replaced. If the chime sound is heard, check the DTC, wiring harness and cable connections.
scientia non olet · About LEMON Manuals