Rear Power Window Switch Inspection

Disconnect the negative (-) battery terminal.
Remove the rear door trim.
(Refer to "REAR DOOR ")
Disconnect the 8P connector from the switch.

Fig 1: Identifying Switch 8P Connector
Courtesy of HYUNDAI MOTOR CO.
Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
[Safety Window]

Fig 2: Safety Window Terminals Position Chart
Courtesy of HYUNDAI MOTOR CO.

[Manual Power Window]

Fig 3: Manual Power Window Terminals Position Chart
Courtesy of HYUNDAI MOTOR CO.