LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2009 >> Elantra GLS, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing - Automatic Transmission >> Automatic Transaxle Control System >> Input Speed Sensor >> Installation

Input Speed Sensor: Installation

  1. Install the new O-ring to the input shaft speed sensor.
  2. Install the input shaft speed sensor (A).

    TORQUE: 

    10~12Nm (1.0~1.2kgf.m, 7~8lb-ft)

    CAUTION: While installing the input shaft speed sensor, do not allow dust or other foreign particles to enter the transaxle.
    Fig 1: Identifying Input Shaft Speed Sensor
    G05364271Courtesy of HYUNDAI MOTOR CO.
  3. Check the connector for dust, dirt, or oil, and then connect the input shaft speed sensor connector (A) securely.
    Fig 2: Identifying Input Shaft Speed Sensor Connector
    G05364270Courtesy of HYUNDAI MOTOR CO.
  4. Installation is the reverse of removal.
scientia non olet · About LEMON Manuals