Component Inspection

Check Heater resistance.

IG "OFF".
Disconnect HO2S (B1S2) connector.

Measure resistance between terminal 3 and 4 of HO2S (B1S2) connector (Component Side).

Specification :

DTC P0141 HEATER RESISTANCE

Item	Specification
Heater Resistance	Approx. 9.0 at 20°C (68°F)

Fig 1: Measuring Resistance Between Terminal 3 And 4 Of HO2S (B1S2) Connector

G04801660

Courtesy of HYUNDAI MOTOR CO.

Is the measured resistance within specification?
YES
- Substitute with a known - good ECM/PCM and check for proper operation.
- If the problem is corrected, replace ECM/PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good HO2S and check for proper operation.
- If the problem is corrected, replace HO2S and go to "VERIFICATION OF VEHICLE REPAIR " procedure.