LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2009 >> Accent GLS, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (1 Of 2) >> P0130 O2 Sensor Circuit (Bank 1/Sensor 1) >> DTC Detecting Condition

P0130 O2 Sensor Circuit (Bank 1/Sensor 1): DTC Detecting Condition

DTC P0130 DETECTING CONDITION TABLE

Item Detecting Condition Possible Cause
DTC Strategy
  • Rationality check
  • Poor connection
  • Open or short power/ground in signal circuit
  • B1S1
  • ECM/PCM
General Enable Conditions
  • Dew point end detected
  • Required lambda = 1
  • Battery voltage > 10.7V
  • Exhaust gas temperature (model) < 800°C (1472°F)
  • Heater control enabled
Case1 Enable Conditions
  • B1S2 sensor voltage > 0.5V
Threshold Value
  • B1S1 sensor voltage: 0.06 ~ 0.4V
Diagnostic Time
  • 25 sec.
Case2 Enable Conditions
  • B1S2 sensor voltage < 0.1V
Threshold Value
  • B1S1 sensor voltage: 0.6 ~ 1.08V
Diagnostic Time
  • 10 sec
Case3 Enable Conditions
  • Time after dew point end detected > 10s
Threshold Value
  • Counter of | Δ usvk > 2V during 0.04 sec after heater on → off |) 5 times
MIL ON Condition
  • 2 driving cycle
Δ usvk: Sum of the signal voltage change value (B1S1)
B1S1: upstream oxygen sensor/B1S2: downstream oxygen sensor