Power Supply Circuit Inspection

Ignition "ON" & Engine "OFF".
Disconnect the "INPUT SPEED SENSOR" connector.
Measure voltage between terminal "3" of the OUTPUT SPEED SENSOR harness connector and chassis ground.
Specification: approx. B+

Fig 1: Measuring Voltage Between Terminal Of 3 Output Speed Sensor Harness Connector And Chassis Ground
Courtesy of HYUNDAI MOTOR CO.
Is voltage within specification?
YES : --> Go to "GROUND CIRCUIT INSPECTION " procedure.

NO : --> Check for open in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure.