Inspection Procedure: Notes

[2.7]

PROBLEM VERIFICATION
1. Connect the hi-scan (pro) to data link connector.
2. Turn the ignition switch to ON and verify the DTC "P1693" is displayed.
3. Erase the DTC "P1693" with the hi-scan (pro) and then monitor again.
4. Is the same code displayed?
  NO
  - Problem is intermittent and ICM memory was not cleared.
  YES
  - Key teaching procedures
KEY TEACHING PROCEDURE
1. The key teaching is done after replacing a defective ICM for providing of additional keys to the vehicle owner.
2. Connect the hi-scan (pro) to data link connector.
3. Turn the ignition switch to ON and select "TEACHING" mode of immobilizer system on the hi-scan (pro).
4. Input the pin code which consists of 6 digits.
  NOTE: Because the pin code is security code, contact authorized HMC service staff to know the pin code.
5. If incorrect pin code is inputted for 3 consecutive times, ICM should disallow key teaching function for 1 hours.
6. If the data is correct, the key teaching is completed.
7. Is the key taught completely?
  NO
  - Check for these problems;
    - Storage of invalid data in transponder.
    - Different kind of transponder.
    - Omitted transponder in the key.
  YES
  - Check if DTC "P1693" is displayed again
CHECK IF DTC "P1693" IS DISPLAYED AGAIN
1. Connect the hi-scan (pro) to data link connector.
2. Turn the ignition switch to ON and verify the DTC "P1693" is displayed.
3. Is the same code displayed?
  NO
  - Problem is intermittent and ICM memory was not cleared.
  NO
  - Replace the key set assembly and key teaching must be done.