Check Ftps

IG "OFF" and connect scatool to DLC (Data Link Connector).

Monitor "FTPS" parameter on service data.

SPECIFICATION :

FTPS SPECIFICATION

Pressure (kPa)	Output Voltage (V)
-3.75	4.5
0	1.5
1.25	0.5

Does the "FTPS" parameter change after acceleration ?
YES:
- Fault is intermittent. Drive the vehicle to satisfy the enable condition then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO:
- Substitute with a known - good FTPS and check for proper operation.
- If the problem is corrected, replace FTPS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.