Charging System: Alternator: Disassembly

If the front bearing needs replacing, remove the pulley with a hexagonal wrench.
Remove the generator cover (A) after removing the three nuts (B).

Fig 1: Identifying Generator Cover And Nuts
Courtesy of HYUNDAI MOTOR CO.
Remove the brush holder (A).

Fig 2: Identifying Brush Holder
Courtesy of HYUNDAI MOTOR CO.
Remove the four screws, the rectifier (B) and the rubber seal (C).

Fig 3: Identifying Rectifier And Rubber Seal
Courtesy of HYUNDAI MOTOR CO.
Remove the four nuts (A) and insulators (B).

Fig 4: Identifying Insulators And Nuts
Courtesy of HYUNDAI MOTOR CO.

Fig 5: Identifying Insulators And Nuts
Courtesy of HYUNDAI MOTOR CO.
Remove the rear bracket assembly (A) and washer (B).

Fig 6: Identifying Rear Bracket Assembly And Washer
Courtesy of HYUNDAI MOTOR CO.
Remove the rotor (A) from the stator and front frame assembly (B).

Fig 7: Identifying Rotor, Stator And Front Frame Assembly
Courtesy of HYUNDAI MOTOR CO.